Turf Supplies

A Cultivated turf allows you to enjoy a lawn of instant beauty and maturity without the usual time-consuming hassles of seeding. When purchasing turf grass, be sure to check with a highly reviewed turf supplies shop for a consultation and to purchase all the supplies you will need for the project.

football turf

The following are the basic steps to a beautiful lawn.

STEP 1 – Measuring the Space

With a tape measure, measure the area of your targeted lawn. Include these measurements on a sketch of the lawn area, with the length, width, and any unusual features. Give these measurements to your turf supply specialist so that they can determine the amount of turf you will need.

 

STEP 2 – Prepare the Soil

Minimize drainage problems by having the soil slope away from foundations. Dig the area to a depth of 10 to 15 cm. (4 to 6 in.) Then rake in fertilizer, compost, etc. as need to a depth of 7 to 10 cm. (3 to 4 in.). Rake and smooth the soil removing rocks, roots, and large clods. Roll the area lightly with a lawn roller 1/3 full of water. This will firm the soil surface and reveal low areas that need more soil. Keep the level 2 to 3 cm. (1 in.) below sidewalks or driveway.

Next, to settle the soil and provide a moist base for the turf you’ll need to water the prepared area. Moistening to a depth of 15 cm. (6 in.) is recommended for most soils. However, consult with your local TPI member regarding your specific soil needs.

 

STEP 3 – Turf Installation

Install your lawn immediately upon delivery. Begin watering lawn within 30 minutes of installation. Turf is a living plant that requires ground contact and moisture to survive!

installation-guide-2.jpg In hot weather, protect unlaid turf by placing stacks in shade, covering with moist burlap sacking, and/or sprinkling.

Begin installing turf along the longest straight line, such as a driveway or sidewalk. Butt and push edges and ends against each other tightly, without stretching. Avoid gaps or overlaps. Stagger the joints in each row in a brick-like fashion, using a large sharp knife to trim corners, etc. Avoid leaving small strips at outer edges as they will not retain moisture. On slopes, place the turf pieces across the slope.

To avoid causing indentations or air pockets avoid repeated walking or kneeling on the turf while it is being installed or just after watering.

After installing the turf, roll the entire area to improve turf/soil contact and remove air pockets.

 

STEP 4 – Watering

installation-guide-3.jpg Give your new lawn at least 2 to 3 cm. (1 in.) of water within 1/2 hour of installation. Water daily, or more often, keeping turf moist until it is firmly rooted (about 2 weeks). Then less frequent and deeper watering should begin.

Weather conditions will dictate the amount and frequency of watering. Be certain that your new lawn has enough moisture to survive hot, dry, or windy periods. Water areas near building more often where reflected heat dries the turf.

 

turf

Caution:

During the first three weeks, avoid heavy or concentrated use of your new lawn. This gives the roots an opportunity to firmly knit with the soil, and insures that the turf will remain smooth.

 

 

Maintenance:lawns

Your new sod lawn increases your property value significantly. With proper care, it will remain a great asset, providing beauty, a clean playing surface, and an improved environment.

 

Mow often, generally removing no more than 1/3 of the grass height at a mowing. Keep your mower blade sharp. Follow local TPI mowing recommendations for your type of lawn.

 

Leave a Reply

Your email address will not be published. Required fields are marked *